Anchor Hocking Glass NAVI-TRAC NAV40GBL-1104 User Manual download pdf (Page 3)

40’ Gabled Navi-Trac Frame Terminology

INTRODUCTION:

Like the hip-end version, the gabled end NAVI-TRAC frame is made up of extruded aluminum members joined

by weldments. The aluminum frame members themselves are extruded with channels into which the NAVI-

TRAC fabric “kedar” is fed. However, the gabled end version of the Navi-Trac differs from the Hip End version

in a number of ways:

1. All the beams are parallel to each other.

2. Beam base plates are hinged for pivoting to a vertical position. End Upright plates are fixed, non-pivoting.

3. The eave fittings are the MCW style that allows a simple drop-in action for purlin installation, rather

than the slip joint of the hip end configuration.

4. Fabric middle bays are installed into the channels of adjacent beams one bay at a time.

5. Gabled End fabric is intalled simply into the outer channel of the end beams and tensioned to the

Gabled End uprights.

6. X-Cabling extends into the overhead rafter area to compensate for the lack of hip end support.

7. Corner guys are in one direction only, parallel to the beams.

It is possible to combine the hip end and gabled end styles within one building unit (see kit #3); however

this assembly manual focuses on the gabled end configuration only. The last few pages describe the

hip/gabled combination and refer the customer to the hip end assembly manual for the hip end part of

the building unit.

R21-9

P1, P2 OR P3

(OPTIONAL)

BHW

RWE

T-42

X-4, 5 or 6

(OPTIONAL

BAY SPACING)

X-1, 2 or 3

(OPTIONAL BAY

SPACING

MCW

X-7, 8 or 9

(OPTIONAL

BAY SPACING)

EE10

ER10, 15, 0R 20

(OPTIONAL)

BFW

T-30

EW15

XRB

MCW

UGT

UG-15

GRW

See Component List Table on

Pages 5 & 6 for component

descriptions.

1 2 3 4 5 6 7 8 ... 15 16

Comments to this Manuals

No comments

Anchor Hocking Glass NAVI-TRAC NAV40GBL-1104 User Manual Page 3

Comments to this Manuals